Dining Table and Chairs

 

One of the more interesting piece that I have made so far is a padouk and mahogany dining table. The piece is interesting not so much for its design, which is essentially mission style, and which was borrowed from the book Making Contemporary Wooden Tables by Thomas Stender, but because of the starting material that went into it. The top was made from a padouk board that was 10 feet long, 28 inches wide and 1 3/4 inches thick, purchased from Yukon Lumber in Norfolk, Virginia (the staff there remarked that in more than 20 years in business, they had not seen boards like this). This board included sapwood at both edges, which was retained in the table. To bring the top to the `standard' dining-table width of 42 inches, two other padouk boards were attached to the larger board, with the sapwood forming a natural, irregularly shaped inlay on the completed table top.

 

Padouk Dining Table: boards for the table top.

 

The base of the table is made of mahogany, with padouk slats. The finish on the base is a burnished oil finish, with three coats of Danish oil, burnished after the third coat, and waxed. The top was treated in much the same way, but it received four coats of Danish oil.

The slats in the base are 3/8" padouk, while the rest of the base is mahogany.

 

Padouk Dining Table: the table base.

 

Padouk Dining Table: after first coat of oil.

  

 

Padouk Dining Table: the finished product.

 

I have made 10 chairs to go with the dining table. The image below shows one during the construction phase, with a black seat taken from another chair. The completed chair seats are upholstered in an African print. I did the upholstery myself, another skill I had to learn to complete this project. 

The curved portions of the chairs are steam-bent mahogany. This means I had to learn how to steam-bend wood. The legs are also mahogany, while the slats in the back are padouk.

Padouk and Mahogany Dining Chair.

 

The completed set.